U-Boot 1.1.6-cirrus-edb93xx-platform (Jan 5 2008 - 18:48:56) DRAM total 4 banks: bank base-address size 0 00000000 00800000 1 01000000 00800000 2 04000000 00800000 3 05000000 00800000 DRAM: 32 MB Flash: 16 MB,16-bits In: serial Out: serial Err: serial Hit any key to stop autoboot: 0 EDB9302> printenv bootdelay=2 baudrate=57600 ethaddr=01:02:93:12:15:07 bootfile="vmlinux.gz.img" mtdids=nor0=physmap-flash.0 mtdparts=mtdparts=physmap-flash.0:768k@0(Firmware),2048k@0xc0000(Kernel),-@0x2c0000(Root-FS) bootargs1=rootfstype=jffs2 root=/dev/mtdblock2 mtdparts=physmap-flash.0:768k@0(Firmware),2048k@0xc0000(Kernel),-@0x2c0000(Root-FS) bootargs2=root=/dev/ram console=ttyAM mtdparts=physmap-flash.0:768k@0(Firmware),2048k@0xc0000(Kernel),-@0x2c0000(Root-FS) bootcmd1=tftp 0x200000 uImage; bootm 0x200000 bootcmd2=tftp 0x200000 uImage; tftp 0x400000 ramdisk.gz.img; bootm 0x200000 0x400000 filesize=18e000 fileaddr=400000 gatewayip=192.168.0.200 netmask=255.255.255.0 ipaddr=192.168.0.200 serverip=192.168.0.114 partition=nor0,0 mtddevnum=0 mtddevname=Firmware bootcmd=tftp 0x200000 uImage; bootm 0x200000 bootargs3=root=/dev/sda1 rootdelay=10 console=ttyAM bootargs5=console=ttyAM rootfs=cramfs root=/dev/mtdblock2 mtdparts=physmap-flash.0:768k@0(Firmware),2048k@0xc0000(Kernel),-@0x2c0000(Root-FS) bootargs4=console=ttyAM root=/dev/mmcblk0p1 rootdelay=5 mtdparts=physmap-flash.0:768k@0(Firmware),2048k@0xc0000(Kernel),-@0x2c0000(Root-FS) bootargs=console=ttyAM rootfs=cramfs root=/dev/mtdblock2 mtdparts=physmap-flash.0:768k@0(Firmware),2048k@0xc0000(Kernel),-@0x2c0000(Root-FS) newfs=tftp 0x400000 rootfs.cramfs;erase nor0,2;cp.b 0x400000 0x602c0000 ${filesize} stdin=serial stdout=serial stderr=serial Environment size: 1400/131067 bytes EDB9302> setenv bootargs ${bootargs4} EDB9302> boot TFTP from server 192.168.0.114; our IP address is 192.168.0.200 Filename 'uImage'. Load address: 0x200000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ####################################################### done Bytes transferred = 1610996 (1894f4 hex) ## Booting image at 00200000 ... Image Name: Linux-2.6.24-rc8 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1610932 Bytes = 1.5 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK Starting kernel ... Uncompressing Linux...................................................................................................... done, booting the kernel. Linux version 2.6.24-rc8 (ivanovp@pc1501sd) (gcc version 4.1.1) #23 PREEMPT Thu Jan 17 15:11:57 CET 2008 CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177 Machine: Cirrus Logic EDB9302 Evaluation Board Memory policy: ECC disabled, Data cache writeback CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8016 Kernel command line: console=ttyAM root=/dev/mmcblk0p1 rootdelay=5 mtdparts=physmap-flash.0:768k@0(Firmware),2048k@0xc0000(Kernel),-@0x2c0000(Root-FS) PID hash table entries: 128 (order: 7, 512 bytes) Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 8MB 8MB 8MB 8MB = 32MB total Memory: 29140KB available (2932K code, 268K data, 104K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok net_namespace: 64 bytes NET: Registered protocol family 16 ep93xx: PLL1 running at 400 MHz, PLL2 at 192 MHz ep93xx: FCLK 200 MHz, HCLK 100 MHz, PCLK 50 MHz SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 2, 20480 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered NetWinder Floating Point Emulator V0.97 (extended precision) JFFS2 version 2.2. (NAND) þþ 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler deadline registered (default) Serial: AMBA driver $Revision: 1.41 $ apb:uart1: ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA console [ttyAM0] enabled apb:uart2: ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA apb:uart3: ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA loop: module loaded nbd: registered device at major 43 usbcore: registered new interface driver catc drivers/net/usb/catc.c: v2.8 CATC EL1210A NetMate USB Ethernet driver drivers/net/usb/rtl8150.c: rtl8150 based usb-ethernet driver v0.6.2 (2004/08/27) usbcore: registered new interface driver rtl8150 usbcore: registered new interface driver rtl8187 Driver 'sd' needs updating - please use bus_type methods physmap platform flash device: 01000000 at 60000000 physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank Intel/Sharp Extended Query Table at 0x0031 Using buffer write method cfi_cmdset_0001: Erase suspend on write enabled 3 cmdlinepart partitions found on MTD device physmap-flash.0 Creating 3 MTD partitions on "physmap-flash.0": 0x00000000-0x000c0000 : "Firmware" 0x000c0000-0x002c0000 : "Kernel" 0x002c0000-0x01000000 : "Root-FS" ep93xx-spi ep93xx-spi.0: SPI Controller initalized ep93xx-ohci ep93xx-ohci: EP93xx OHCI ep93xx-ohci ep93xx-ohci: new USB bus registered, assigned bus number 1 ep93xx-ohci ep93xx-ohci: irq 56, io mem 0x80020000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 3 ports detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usbcore: registered new interface driver usbserial drivers/usb/serial/usb-serial.c: USB Serial Driver core drivers/usb/serial/usb-serial.c: USB Serial support registered for pl2303 usbcore: registered new interface driver pl2303 drivers/usb/serial/pl2303.c: Prolific PL2303 USB to serial adaptor driver ep93xx-rtc ep93xx-rtc: rtc core: registered ep93xx as rtc0 i2c /dev entries driver ep93xx_wdt: EP93XX watchdog, driver version 0.3 (nCS1 disable detected) mmc_spi spi0.43: ASSUMING SPI bus stays unshared! mmc_spi spi0.43: MMC/SD card detection IRQ 81 assigned. mmc_spi spi0.43: MMC/SD card detection IRQ 82 assigned. mmc_spi spi0.43: Serial EEPROM AT25F1024 disabled. mmc_spi spi0.43: SD/MMC host mmc0, no DMA, no poweroff TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 10 NET: Registered protocol family 17 NET: Registered protocol family 15 RPC: Registered udp transport module. RPC: Registered tcp transport module. ieee80211: 802.11 data/management/control stack, git-1.1.13 ieee80211: Copyright (C) 2004-2005 Intel Corporation ep93xx-rtc ep93xx-rtc: setting system clock to 1970-01-01 01:34:20 UTC (5660) Waiting 5sec before mounting root device... mmc0: new SD card on SPI mmcblk0: mmc0:0000 SD01G 1006080KiB mmcblk0: p1 kjournald starting. Commit interval 5 seconds EXT3 FS on mmcblk0p1, internal journal EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem). Freeing init memory: 104K INIT: version 2.86 booting Activating swap...done. Checking root file system...fsck 1.40-WIP (14-Nov-2006) root: clean, 16473/125952 files, 61034/251519 blocks done. EXT3 FS on mmcblk0p1, internal journal FATAL: Module rtc_dev not found. Setting the system clock.. Cleaning up ifupdown.... Loading device-mapper support. Checking file systems...fsck 1.40-WIP (14-Nov-2006) done. Setting kernel variables...done. Mounting local filesystems...done. Activating swapfile swap...done. Setting up networking.... Configuring network interfaces...Internet Systems Consortium DHCP Client V3.0.4 Copyright 2004-2006 Internet Systems Consortium. All rights reserved. For info, please visit http://www.isc.org/sw/dhcp/ Listening on LPF/eth0/00:de:ad:b0:05:00 Sending on LPF/eth0/00:de:ad:b0:05:00 Sending on Socket/fallback DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 6 DHCPOFFER from 192.168.0.114 DHCPREQUEST on eth0 to 255.255.255.255 port 67 DHCPACK from 192.168.0.114 bound to 192.168.0.200 -- renewal in 271 seconds. done. Starting portmap daemon.... INIT: Entering runlevel: 2 Starting system log daemon: syslogd. Starting kernel log daemon: klogd. Starting portmap daemon...Already running.. Starting internet superserver: inetd. Starting OpenBSD Secure Shell server: sshd. Starting NFS common utilities: statd. Starting deferred execution scheduler: atdStarting periodic command scheduler: crond. Debian GNU/Linux 4.0 cs-e9302 ttyAM0 cs-e9302 login: root Password: Last login: Thu Jan 1 02:31:25 1970 on ttyAM0 Linux cs-e9302 2.6.24-rc8 #23 PREEMPT Thu Jan 17 15:11:57 CET 2008 armv4tl The programs included with the Debian GNU/Linux system are free software; the exact distribution terms for each program are described in the individual files in /usr/share/doc/*/copyright. Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent permitted by applicable law. No mail. cs-e9302:~# ls -la total 36 drwxr-xr-x 4 root root 4096 Jan 1 01:31 . drwxr-xr-x 22 root root 4096 Jan 18 2008 .. drwx------ 2 root root 4096 Oct 15 2007 .aptitude -rw------- 1 root root 151 Jan 1 02:33 .bash_history -rw-r--r-- 1 root root 422 Jan 12 2008 .bashrc -rw------- 1 root root 43 Oct 15 2007 .lesshst -rw-r--r-- 1 root root 110 Oct 15 2007 .profile drwx------ 2 root root 4096 Oct 15 2007 .ssh -rw------- 1 root root 561 Jan 12 2008 mbox cs-e9302:~# df -h Filesystem Size Used Avail Use% Mounted on /dev/mmcblk0p1 968M 223M 695M 25% / tmpfs 15M 0 15M 0% /lib/init/rw tmpfs 15M 0 15M 0% /dev/shm cs-e9302:~# cat /proc/cpuinfo Processor : ARM920T rev 0 (v4l) BogoMIPS : 99.73 Features : swp half thumb crunch CPU implementer : 0x41 CPU architecture: 4T CPU variant : 0x1 CPU part : 0x920 CPU revision : 0 Cache type : write-back Cache clean : cp15 c7 ops Cache lockdown : format A Cache format : Harvard I size : 16384 I assoc : 64 I line length : 32 I sets : 8 D size : 16384 D assoc : 64 D line length : 32 D sets : 8 Hardware : Cirrus Logic EDB9302 Evaluation Board Revision : 0000 Serial : 0000000000000000 cs-e9302:~#